How To Make A Leader Video

We were asked how we made our leaders for fishing out at the Jetty. I thought it would be fun to make a video explaining and showing how we make them.

Please understand - these are leaders for bottom fishing from a boat or pier. I have no idea how to make leaders for surf ... so ...

Here is the video - and again - it only works with Explorer Web Browser.

Click here to watch it.

Any comments are welcomed!

Mark

Popular posts from this blog

Historical Information on Galveston's North and South Jetty

Image
I have been doing some research on the History of Galveston's North and South Jetties. Here is a paper published about 20 years ago - very informative - a little technical, but still an amazing find. Construction and Rehabilitation History of the Galveston Jetties Costal Hydraulics Laboratory Fact Sheet Galveston Harbor Jetty, Galveston Texas www.tpub.com Tech Report 9 1874-1879 The first attempt at constructing jetties was begun by placing cement covered gabions over distances of 9,700 and 2,200 ft. on the north (Bolivar Point jetty) and south (Fort Point jetty) sides of the inlet, respectively. An additional 500 ft of north jetty was constructed of timber piling at its landward end. The gabions were 6 ft high and wide, from 6 to 12 ft long, and filled with dredged sand once positioned. The jetties were submerged, extending no higher with the majority from 5 to 6 ft below than mean low water (mlw). The gabionades were unsuccessful in either securing a
Read more

Black Drum Run: How To Vent Black Drum

Image
Venting the air bladder on Bull Reds and Big Black Drum. Right now the Black Drum Run is on. While at the jetty today - I saw numerous drum caught - pictures taken - then dumped back in the water - floating belly up because they did not empty the air bladder. I thought it would be good to post instructions on how to do this so we can assure the survival rate of these fish. Below are the instructions. What I have found that works great is a Turkey Spice Injector - I bought mine at Academy for $3.50. It works great! Here are directions: Venting trapped gases from a fish caught from deep water Use the largest hypodermic needle you can find (#10 or larger) and remove the plunger. Insert hypodermic needle at a 45 degree angle, under a scale, near the tip of the pectoral fin and squeeze the fish gently. You will hear the trapped gases escaping. Make a needle clearing tool from a piece of stainless leader wire to clear any tissue, etc. from the needle and leave this tool in the need
Read more